Removal [01/2017 - 05/2023]: Procedure

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [01/2017 - 05/2023]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to REMOVAL [01/2017 - 05/2023]
REMOVE INNER LUGGAGE COMPARTMENT TRIM COVER LH
Refer to DISASSEMBLY [01/2017 - 01/2021] , or refer to DISASSEMBLY [01/2021 - 05/2023]

REMOVE NO. 1 DECK BOARD BRACKET LH

Remove the bolt, nut and No. 1 deck board bracket LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE FUEL PUMP CONTROL ECU BRACKET

WARNING:

After removing the brake control power supply with bracket assembly from the vehicle, there may be an electrical charge left in the internal capacitor. If planning to inspect the inside of the brake control power supply with bracket assembly, leave it as is for more than 24 hours (to discharge it) after removing it from the vehicle. Then, perform the inspection.

Disconnect the brake control power supply connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the 2 fuel pump control ECU connectors.

Detach the clamp

Remove the 2 bolts, nut and fuel pump control ECU bracket from the vehicle body.

REMOVE BRAKE CONTROL POWER SUPPLY WITH BRACKET ASSEMBLY

Remove the 2 nuts and brake control power supply with bracket assembly from the fuel pump control ECU bracket.