FixVault
Home › Lexus › 2021 › LS 500h AWD › Repair and Diagnosis › Suspension › Suspension Control Systems › Suspension Control System - Service Information › Front Acceleration Sensor › Removal [10/2020 - 11/2021] › Procedure

Removal [10/2020 - 11/2021]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [10/2020 - 11/2021]

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to REMOVAL [10/2020 - 11/2021]

  3. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 6

  4. REMOVE FRONT DOOR SCUFF PLATE RH 

    Refer to PROCEDURE - Step 10

  5. REMOVE COWL SIDE TRIM BOARD LH 

    Refer to PROCEDURE - Step 9

  6. REMOVE COWL SIDE TRIM BOARD RH 

    Refer to PROCEDURE - Step 13

  7. REMOVE ACCELERATION SENSOR ASSEMBLY 
    1. for LH Side:
      1. Fold back the floor carpet.
      2. Remove the nut and acceleration sensor.
        NOTE:
        • Avoid any impact to the acceleration sensor.
        • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
        GTY834120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Disconnect the connector from the acceleration sensor.
    2. for RH Side:
      1. Fold back the floor carpet.
      2. Remove the nut and acceleration sensor.
        NOTE:
        • Avoid any impact to the acceleration sensor.
        • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
        GTY813524Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Disconnect the connector from the acceleration sensor.
About FixVault