Inspection [10/2014 - 09/2017]: Procedure

Refer to PROCEDURE - Step 8 [10/2014 - ]

1. Measure the resistance according to the value (s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (No. 2 Combination Switch Assembly (AWD Lock Mode Switch))

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   5(B) - 17(GND)	ON	Below 1 Ω
   	OFF	10 kΩ or higher

   If the result is not as specified, replace the No. 2 combination switch assembly (AWD lock mode switch).

2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the No. 2 combination switch assembly (AWD lock mode switch).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component without harness connected (No. 2 Combination Switch Assembly (AWD Lock Mode Switch))
   *b	No. 2 Combination Switch Assembly (AWD Lock Mode Switch) Illumination

   Standard

   Measurement Condition	Specified Condition
   Battery positive (+) → 8 (ILL+) Battery negative (-) → 15 (ILL-)	Illuminates

   If the result is not as specified, replace the No. 2 combination switch assembly (AWD lock mode switch).

Refer to PROCEDURE - Step 2 [10/2014 - ]