FixVault
Home › Lexus › 2021 › RC F Base › Repair and Diagnosis › Body & Frame › Seats › Seats - Service Information › Limit Switch › Inspection [09/2014 - ] › Procedure

Inspection [09/2014 - ]: Procedure

  1. INSPECT INNER LIMIT SWITCH ASSEMBLY (FRONT SEATBACK EDGE PROTECTOR) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY497821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Inner Limit Switch Assembly (Front Seatback Edge Protector))

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 Inner limit switch pressed Below 1 Ω
      Inner limit switch not pressed 10 kΩ or higher

      If the result is not as specified, replace the inner limit switch assembly (front seatback edge protector).

  2. INSPECT OUTER LIMIT SWITCH ASSEMBLY (FRONT SEATBACK EDGE PROTECTOR) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY497821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Outer Limit Switch Assembly (Front Seatback Edge Protector))

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 Outer limit switch pressed Below 1 Ω
      Outer limit switch not pressed 10 kΩ or higher

      If the result is not as specified, replace the outer limit switch assembly (front seatback edge protector).

About FixVault