FixVault
Home › Lexus › 2021 › RC F Fuji Speedway Edition › Repair and Diagnosis › Accessories & Equipment › Infotainment › Navigation System - Service Information › Navigation Ecu › Installation [11/2017 - ] › Procedure

Installation [11/2017 - ]: Procedure

  1. PRECAUTION 
    NOTE:
    • When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
      • A communication malfunction DTC may be stored.
      • The radio receiver assembly or navigation ECU may not operate normally.
    • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio receiver assembly.
  2. INSTALL NAVIGATION ECU 
  3. INSTALL RADIO RECEIVER ASSEMBLY 
  4. INSTALL NO. 2 RADIO BRACKET 

    Refer to PROCEDURE - Step 4 [11/2017 - 03/2019] , or refer to PROCEDURE - Step 4 [03/2019 - ]

  5. INSTALL NO. 1 RADIO BRACKET 

    Refer to PROCEDURE - Step 5 [11/2017 - 03/2019] , or refer to PROCEDURE - Step 5 [03/2019 - ]

  6. INSTALL NO. 1 NAVIGATION WIRE 
    1. Connect the 2 connectors to install the No. 1 navigation wire.
  7. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET 

    Refer to PROCEDURE - Step 7 [11/2017 - 03/2019] , or refer to PROCEDURE - Step 7 [03/2019 - ]

  8. INSTALL CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5 [09/2014 - 03/2019] , or refer to PROCEDURE - Step 5 [03/2019 - ]

  9. INSTALL FRONT PANEL GARNISH RH 

    Refer to PROCEDURE - Step 8 [09/2014 - 03/2019] , or refer to PROCEDURE - Step 8 [03/2019 - ]

  10. INSTALL FRONT PANEL GARNISH LH 

    Refer to PROCEDURE - Step 9 [09/2014 - 03/2019] , or refer to PROCEDURE - Step 9 [03/2019 - ]

  11. INSTALL INSTRUMENT PANEL FINISH PANEL END RH 

    Refer to PROCEDURE - Step 10 [09/2014 - 03/2019] , or refer to PROCEDURE - Step 10 [03/2019 - ]

  12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 11 [09/2014 - 03/2019] , or refer to PROCEDURE - Step 11 [03/2019 - ]

  13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 12 [09/2014 - 03/2019] , or refer to PROCEDURE - Step 12 [03/2019 - ]

About FixVault