Installation [09/2014 - ]: Procedure

1. Clean the installation surfaces of the oil cooler assembly.
2. Install a new O-ring to the oil cooler assembly.
3. Clean the installation surfaces of the oil thermostat housing assembly.
4. Install a new O-ring to the oil thermostat housing assembly.
5. Apply a small amount of engine oil to the oil cooler union bolt.
6. Install the oil thermostat housing assembly, oil cooler assembly and a new gasket with the oil cooler union bolt and bolt.

   Oil Cooler Union Bolt 

   Torque: 59 N.m (602 kgf/cm, 44 ft.lbf) 

   Bolt 

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

7. Apply a small amount of engine oil to 2 new O-rings and install them to the oil cooler hose sub-assembly.
   NOTE:

   Do not damage the O-rings.

8. Connect the oil cooler hose sub-assembly with the 2 bolts.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

See step  5 [09/2014 - 10/2015], or see step  5 [10/2015 - 11/2021], or see step  5 [11/2021 - ]

Refer to PROCEDURE - Step 1 [09/2014 - 10/2023] , or refer to PROCEDURE - Step 1 [10/2023 - ]

See step  6 [09/2014 - 10/2015], or see step  6 [10/2015 - 11/2021], or see step  6 [11/2021 - ]

Refer to PROCEDURE - Step 94 [09/2014 - 05/2018] , or refer to PROCEDURE - Step 95 [05/2018 - 03/2019] , or refer to PROCEDURE - Step 94 [03/2019 - ]