Installation [08/2023 - ]: Procedure
- INSPECT SPIRAL CABLE SUB-ASSEMBLY
Refer to PROCEDURE - Step 1 - INSTALL STEERING SENSOR
*a Guide *b Pin *c Lock Pin - - - Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.NOTE:
- Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.
- Do not damage the claws or pins of the spiral cable sub-assembly or guides of the steering sensor.
- The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.
- Remove the lock pin from the steering sensor.
- Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
- INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 3 - INSTALL UPPER STEERING COLUMN COVER
- INSTALL LOWER STEERING COLUMN COVER
- ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
- INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 7 - INSTALL STEERING WHEEL ASSEMBLY
Refer to PROCEDURE - Step 7 - INSTALL HORN BUTTON ASSEMBLY
Refer to PROCEDURE - Step 1 - INSTALL LOWER NO. 3 STEERING WHEEL COVER
- INSTALL LOWER NO. 2 STEERING WHEEL COVER
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for T24A-FTS (Gasoline Model): Refer to INSTALLATION [10/2022 - ]
for T24A-FTS (1Motor-HEV Model): Refer to INSTALLATION [10/2022 - ]
for A25A-FXS: Refer to INSTALLATION [08/2023 - ]
- UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [10/2022 - ]
- INSPECT HORN BUTTON ASSEMBLY
Refer to PROCEDURE - Step 5
- CHECK STEERING WHEEL CENTER POINT
Refer to ADJUSTMENT [10/2022 - ]
- INSPECT SRS WARNING LIGHT
Refer to OPERATION CHECK [10/2022 - ]
- CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Refer to PROCEDURE - Step 15
- PERFORM INITIALIZATION AND CALIBRATION
Refer to CAUTION / NOTICE / HINT