Time Delay Check
- Disconnect overtravel lever from link and lines at shock air intake ports. Connect test gauge to intake valve port and apply 95 psi. Move overtravel lever one inch down from neutral position, as measured from end of lever. Quickly move lever upward two inches.
- The delay before air starts to escape from the port should be 4-30 seconds. Remove test gauge and plug intake port with fill valve (female end).
- Connect test gauge to air sleeve port and repeat above test, for downward position of lever. If either delay is not within specifications, there has been a loss of silicone fluid or valve has lost its adjustment due to damage or wear.