Steering Angle Sensor Resistance
WARNING: This page is about a different car, the 1992 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition off. Remove steering column cover and disconnect steering angle sensor 3-wire connector. Place steering wheel in straight-ahead position. Measure resistance between wires as specified. See STEERING ANGLE SENSOR RESISTANCE TABLE. If resistance is within specification, proceed to PINPOINT TEST B3. If resistance is not as specified, replace steering angle sensor.
STEERING ANGLE SENSOR RESISTANCE
| Wires | k/ohms |
|---|---|
| Green & Green/White | 0-15 |
| Green & Green/Yellow | 40-60 |
| Green/Yellow & Green/White | 30-50 |