Steering Angle Circuit Continuity Check
WARNING: This page is about a different car, the 1992 Ford Probe. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect steering angle sensor connector. Disconnect PRC control module connector. Set VOM on 200-ohm scale. Measure resistance at PRC control module connector and steering angle sensor connector between: 2 Green wires, 2 Green/White wires and 2 Green/Yellow wires. If resistance in all cases is less than 5 ohms, proceed to PINPOINT TEST B6. If resistance is 5 ohms or more, repair open circuit in appropriate wire.