Power Window Motor: Removal
- Raise window to full up position (if possible) and support. Disconnect battery ground cable. Remove inner door trim panel and protective cover.
- Locate and mark area of door panel covering motor mounting screws. Some models may have dimples over mounting screw locations. Disconnect motor wiring connector. Ensure that no wires are routed directly under area to be drilled.
- Using a 3/4" hole saw with a 1/4" pilot, drill inner door panel to expose motor mounting screws. Remove drilled shavings from door.
- Lock regulator arm in fixed position to prevent counterbalance spring from unwinding. Remove motor mounting screws. Remove motor.