FixVault
Home › Lincoln › 1995 › Mark VIII Base › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Engine Controls - Remove/Install/Overhaul - 4.6L › Engine Management › Powertrain Control Module (Pcm) › Removal & Installation

Removal & Installation

  1. Disconnect battery ground cable.
  2. Remove RH cowl side trim panel to expose powertrain control module (PCM).
  3. Loosen engine control sensor wiring to PCM connector retainer bolt.
  4. Remove engine control sensor wiring connector from PCM.
  5. Remove PCM from powertrain control module bracket (PCM bracket) by pulling powertrain control module downward.
  6. To install, reverse Removal procedure. Tighten engine control sensor wiring connector retainer bolt to 2.7-3.7 N-m (24-32 lb-in).
About FixVault