FixVault

Wiper Switch Continuity Test

NOTE: Windshield wiper switch is an integral part of the multifunction switch located on steering column. Multifunction switch is serviced as an assembly.

Unplug multifunction switch connector located under steering column. Using a DVOM, test between specified terminals. See Fig 1 . See the WIPER SWITCH CONTINUITY TEST  table. Replace switch if readings are not as specified.

WIPER SWITCH CONTINUITY TEST

Switch Position Terminals No. Resistance: k/ohms
Wiper
OFF 4 & 1 47.6
INT 4 & 1 11.33
INT 4 & 6 (1)
LO 4 & 1 4.08
HI 4 & 1 0
Washer (1)
Pressed 4 & 6 0
Released 4 & 6 103.3
Released 4 & 1 47.6
(1) Rotate INT (interval) knob from minimum to maximum. Resistance should increase gradually from 3.3 k/ohms (MIN) to 103.3 k/ohms (MAX). All measurements should be within 10% of specifications.
Fig 1: Identifying Wiper Switch Terminals (Continental)
G95J13580Courtesy of FORD MOTOR CO.