FixVault
Home › Lincoln › 2002 › Blackwood › Repair and Diagnosis (Single Page) › Body & Frame › Door Locks › Anti-Theft Systems - Passive - BLACKWOOD & F150 Pickup › Programming › Key Programming Using 2 Programmed Keys

Key Programming Using 2 Programmed Keys

NOTE: This procedure will only work if 2 or more programmed ignition keys are available and there is a need to program additional ignition keys. If 2 ignition keys are not available, perform ERASE ALL KEYS & PROGRAM 2 KEYS . PID SPARE_KY must be enabled for this procedure to operate. To enable this PID, perform ENABLE/DISABLE SPARE KEY PROGRAMMING  and enable spare ignition key programming switch. If programming procedure is successful, new ignition key(s) will start vehicle and THEFT indicator will illuminate for 3 seconds. If programming procedure is not successful, new ignition key(s) will not start vehicle and THEFT indicator will flash. If necessary, repeat programming procedure. If programming of ignition key(s) is still unsuccessful, perform procedures in SELF-DIAGNOSTIC SYSTEM . Maximum of 8 ignition keys can be programmed into system. If procedure is not performed as outlined, programming procedure will end. Ignition keys must have correct ignition key cut for vehicle and must be an encoded ignition key.
  1. Insert first programmed ignition key into ignition lock cylinder. Turn ignition switch from LOCK to RUN position (ignition switch must stay in RUN position for one second). Turn ignition switch to LOCK position. Remove ignition key from ignition lock cylinder.
  2. Within 5 seconds of turning ignition switch to LOCK position, insert second programmed ignition key into ignition lock cylinder. Turn ignition switch from LOCK to RUN position (ignition switch must stay in RUN position for one second). Turn ignition switch to LOCK position and remove second ignition key from ignition lock cylinder.
  3. Within 5 seconds of turning ignition switch to LOCK position, insert a NEW unprogrammed ignition key into ignition lock cylinder. Turn ignition switch from LOCK to RUN position (ignition switch must stay in RUN position for one second). Turn ignition switch to LOCK position. Remove ignition key from ignition lock cylinder. The NEW ignition key should now be programmed. To program additional ignition key(s), repeat ignition key programming procedure from step  1.
About FixVault