Removal and Installation

WARNING: This page is about a different car, the 2004 Lincoln Navigator and 2004 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

If equipped, turn the air suspension switch to the OFF position.
Disconnect the wheel speed sensor connector.

Fig 1: Disconnecting Wheel Speed Sensor Connector
Courtesy of FORD MOTOR CO.
Remove the wheel and tire assembly. For additional information, refer to WHEELS & TIRES .
Remove the bolt and detach the retainers.

Fig 2: Removing Bolt And Detaching Retainers
Courtesy of FORD MOTOR CO.

CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can result.

Fig 3: Removing Bolts

Courtesy of FORD MOTOR CO.

Remove the bolts, and position the caliper, pads and anchor plate aside.
Remove the brake disc.

Fig 4: Removing Brake Disc
Courtesy of FORD MOTOR CO.
Remove the bolt and the front wheel speed sensor.

Fig 5: Removing Bolt And Front Wheel Speed Sensor
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.