Removal and Installation

Disconnect the battery ground cable. For additional information, see BATTERY, MOUNTING & CABLES .
Disengage the four retaining clips by first pulling down on the front of the overhead console and then the rear of the overhead console.

Fig 1: Removing Overhead Console
Courtesy of FORD MOTOR CO.
Disconnect the electrical connectors.

Fig 2: Locating Electrical Connectors
Courtesy of FORD MOTOR CO.
Remove the intrusion module from the message center.
1. Disconnect the electrical connector.
2. Remove the screws.
Fig 3: Removing Intrusion Module
Courtesy of FORD MOTOR CO.
Remove the four screws and the message center module.

Fig 4: Removing Message Center Module
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.