FixVault
Home › Lincoln › 2005 › LS 3.0 S › Repair and Diagnosis › Brakes › Traction Control › Anti-Lock Control › Removal And Installation › Anti-Lock Brake System (ABS) Module › Removal and Installation

Removal and Installation

  1. Position the battery junction box (BJB) aside.
    1. Release the clips.
    2. Position the BJB aside.
    Fig 1: Identifying Battery Junction Box Clips
    G03995580Courtesy of FORD MOTOR CO.
  2. Disconnect the ABS electrical connector.
  3. Remove the 3 ABS module screws and the ABS module.
    • To install, tighten to 2 Nm (18 lb-in).
    4. NOTE: Use the diagnostic tool to configure the ABS module. For additional information, refer to MODULE CONFIGURATION .
  4. To install, reverse the removal procedure.
About FixVault