FixVault
Home › Lincoln › 2005 › LS 3.0 S › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle/Transmission › In-Vehicle Repair › Transmission Support Insulator › Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Support the transmission with a transmission jack.
  3. Remove the rear transmission mount outer screws.
    • To install, tighten to 55 Nm (41 lb-ft).
    Fig 1: Locating Rear Transmission Crossmember Mounting Screws
    G03997252Courtesy of FORD MOTOR CO.
  4. Remove the rear transmission mount center screw.
    • To install, tighten to 40 Nm (31 lb-ft).
    Fig 2: Identifying Rear Transmission Mount Center Screw
    G03997315Courtesy of FORD MOTOR CO.
  5. Remove the rear transmission mount.
  6. To install, reverse the removal procedure.
About FixVault