FixVault
Home › Lincoln › 2006 › Mark LT RWD › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Module Configuration - F150 & Mark LT › General Procedures › Programmable Module Installation › Using the Vehicle Communication Module (VCM) When the Original Module is Not Available › Step B - Entering As-Built Data

Step B - Entering As-Built Data

  1. Press the trigger.
  2. If the VCM asks for vehicle data, enter the vehicle data, then press store.
  3. The VCM asks for module data line 1. Enter the data and press store.
  4. The VCM then asks if there is an additional line of data available for that address. Select YES or NO depending on the information in the As Built Data sheet.
  5. Repeat Steps  3 and  4 until the answer is NO for Step  4.
  6. The VCM should show a screen stating that the module data was stored. Press the trigger.
  7. Follow the on-screen instructions.
    NOTE: For vehicle security module (VSM) programming only, refer to steps a-d  below, all others skip to step 8.
    1. Turn the headlamp switch to the OFF position.
    2. Turn the ignition key to the RUN position.
    3. Open the drivers door.
    4. Unlock the doors using the interior trim switch.
  8. SELECT: Restore Configuration - New ECU. Press the trigger.
  9. The VCM completes loading the retrieved data and displays Module Download Successful.
  10. Test the module for correct operation.
About FixVault