Removal And Installation

NOTE: When installing a new stability control sensor cluster, the sensor cluster must be calibrated. Follow the scan tool directions for the calibration procedures.

NOTE: The sensor is located on the RH side of the vehicle, under the rear seat.

Remove the rear seat. For additional information, refer to SEATING article.
Remove the right rear scuff plate. For additional information, refer to INTERIOR TRIM & ORNAMENTATION article.
- Position the carpet aside.
Disconnect the stability control sensor cluster electrical connector.
Remove the 2 stability control sensor cluster nuts and the stability control sensor cluster.
- To install, tighten to 9 Nm (80 lb-in).
To install, reverse the removal procedure.