Removal And Installation

NOTE: Accessory Protocol Interface Module (APIM) reprogramming is only necessary if a new module is being installed.

Verify the current APIM software and hardware level. For additional information, refer to Accessory Protocol Interface Module (APIM) Reprogramming MODULE CONFIGURATION article.
Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
Remove the floor console rear trim panel by pulling straight back to disengage the clips.

NOTE: For Fusion, Milan, the APIM is removed as an assembly with the bracket.

Remove the 2 screws (Fusion, Milan) or 4 screws (MKZ) and the APIM.
- Disconnect the APIM electrical connector.
- Disconnect the Universal Serial Bus (USB) cable.
To install, reverse the removal procedure.
- Reprogram the APIM. For additional information, refer to MODULE CONFIGURATION article.