Cruise-Control Module (C-CM): Installation

Bracket 

1. Install the 3 bolts and the C-CM bracket assembly.
   • Tighten the bolts to 9 Nm (80 lb-in).

   C-CM or bracket 

   NOTE: The vertical and horizontal alignment procedures need to be carried out to align the sensor.
2. Firmly apply pressure to the C-CM so that it seats completely in the grommets.
   NOTE: If one plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.
3. Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
4. Connect the C-CM connector.
   1. Fill the C-CM component connector cavity with the electrical grease.
   2. Connect the C-CM connector.
   3. Disconnect the C-CM connector.
   4. Fill the C-CM component connector cavity with the electrical grease again.
   5. Connect the C-CM connector.
5. Do not install the front bumper cover until the alignment procedures are carried out.
   • Vertically and horizontally align the C-CM. For additional information, refer to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT .