Removal and Installation
- Upload the ACM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
- Remove the Front Controls Interface Module (FCIM). Refer to FRONT CONTROLS INTERFACE MODULE (FCIM) .
- Remove the 4 screws and slide the ACM
out.
- Disconnect the electrical connectors and the antenna cable connectors.
- To install, reverse the removal procedure.
- Download the configuration information to the ACM . For additional information, refer to PMI in MODULE CONFIGURATION .
NOTE:
Module configuration is required when a new ACM
is being installed.