Removal and Installation
WARNING: This page is about a different car, the 2013 Lincoln MKX and 2013 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the FCDIM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION to carry out Programmable Module Installation (PMI).
- Remove the Front Controls Interface Module (FCIM) refer to Front Controls Interface Module (FCIM) .
- Remove the 4 screws and remove the FCDIM.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
NOTE:
Module configuration is required when a new Front Control/Display Interface Module (FCDIM) is being installed.
- Download the configuration information to the FCDIM. For additional information, refer to MODULE CONFIGURATION to carry out PMI.