FixVault
Home › Lincoln › 2013 › MKS Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 175 (Electronic Engine Controls (Gas/Ethanol)) › Removal And Installation › Powertrain Control Module (PCM) › Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the PCM.
  2. Position the PCM wiring harness support bracket and install the 2 nuts.
    • Tighten to 7 Nm (62 lb-in).
  3. Connect the 3 PCM electrical connectors.
    NOTE: If the Programmable Module Installation (PMI) procedure was not successful in downloading the data from the vehicles original PCM, then the oil life data of the vehicle is lost. If this occurs, and the oil life cannot be determined through service history or customer interview, it is recommended the vehicle engine oil and filter be changed and the oil change minder reset.
  4. If the PCM is being replaced, the parameters must be reset. For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  5. If the PCM is being replaced, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
About FixVault