Pinpoint Test T : The FCIM (Front Controls Interface Module) Does Not Respond To The Scan Tool: Notes

WARNING: This page is about a different car, the 2015 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.

The FCIM Does Not Respond To The Scan Tool

Diagnostic Overview

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods

Refer to Wiring Diagrams MODULE COMMUNICATIONS NETWORK for schematic and connector information.

Refer to Wiring Diagrams AUDIO SYSTEM/NAVIGATION for schematic and connector information.

Normal Operation and Fault Conditions

For vehicles equipped with a touchscreen, the FCIM communicates with the scan tool through the I-CAN, and the IPC is used as the gateway module. For vehicles not equipped with a touchscreen, the FCIM does not communicate on the network.

Possible Sources

Fuse
Wiring, terminals and connector
FCIM

Visual Inspection and Diagnostic Pre-checks

Verify BCM fuse 79 (15A) is OK.