Steering Gear: Installation

All vehicles 

1. 1.
   
   Position the steering gear and install the 2 bolts.
   • Tighten to 165 Nm (122 lb-ft).

1. 2.
   
   Connect the 2 EPAS electrical connectors and the wiring retainer.

1. 3.
   
   Position the wiring harness bracket and ground wire, and install the bolt.
   • Tighten to 11 Nm (97 lb-in).

Courtesy of FORD MOTOR COMPANY

1. 4.
   
   Position the flap heat shield and install the bolt.
   • Tighten to 11 Nm (97 lb-in).

1. 5.
   
   Raise the subframe.

1. 6.
   
   Position the 2 subframe support brackets and loosely install the 4 bolts.

1. 7.
   
   Install the 2 front subframe rearward bolts.
   • Tighten the rearward bolts to 150 Nm (111 lb-ft).
   • Tighten the forward bolts to 200 Nm (148 lb-ft).

1. 8.
   
   Tighten the 4 subframe support bracket bolts to 55 Nm (41 lb-ft).

Vehicles equipped with a 3.5L GTDI engine 

1. 9.
   
   Install the 2 front and rear roll restrictor-to-subframe bolts.
   • Tighten to 103 Nm (76 lb-ft).

1. 10.
   
   Install the RH and LH exhaust flexible pipes. For additional information, refer to Exhaust System .

Vehicles equipped with a 2.0L GTDI engine or a 3.5L Ti-VCT engine 

1. 11.
   
   Install the roll restrictor-to-subframe bolt.
   • Tighten to 103 Nm (76 lb-ft).

Vehicles equipped with a 3.7L Ti-VCT engine 

1. 12.
   
   Install the Y-pipe. For additional information, refer to Exhaust System .

1. 13.
   
   Position the roll restrictor heat shield and install the 2 roll restrictor heat shield heat shield nuts.
   • Tighten to 9 Nm (80 lb-in).

All vehicles 

1. 14.
   
   Install the 2 RH engine splash shield-to-subframe pin-type retainers.

1. 15.
   
   Position the underbody shield and install the 4 retainers.

1. 16.
   
   Position the 2 outer tie-rod ends and install the nuts.
   • Tighten to 150 Nm (111 lb-ft).

1. 17.
   
   Connect the stabilizer bar links and install the 2 nuts.
   • Tighten the new nuts to 150 Nm (111 lb-ft).

1. 18.
   
   
   NOTE: Do not allow the steering column shaft to rotate while disconnected from the gear or damage to the clockspring may occur. If there is evidence that the steering column shaft has rotated, remove and recenter the clockspring. For additional information, refer to Supplemental Restraint System .

   With the locator on the input shaft correctly aligned, connect the steering column shaft to the steering gear and install the new bolt.

   • Tighten to 20 Nm (177 lb-in).

1. 19.
   
   Install the wheels and tires. For additional information, refer to Wheels and Tires .

1. 20.
   
   When installing a new steering gear, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to Programmable Module Installation (PMI) in Module Configuration .