Headlamps - Navigator: BCM

DTC INDEX

DTC	Description	Action
B1D00:11	Left Low Beam: Circuit Short To Ground	GO to Pinpoint Test N .
B1D00:15	Left Low Beam: Circuit Short To Battery or Open	If the low beam is inoperative, GO to Pinpoint Test N . If the low beam is always on, GO to Pinpoint Test P .
B1D01:11	Right Low Beam: Circuit Short To Ground	GO to Pinpoint Test N .
B1D01:15	Right Low Beam: Circuit Short To Battery or Open	If the low beam is inoperative, GO to Pinpoint Test N . If the low beam is always on, GO to Pinpoint Test P .
B1D02:11	Left High Beam: Circuit Short To Ground	GO to Pinpoint Test O .
B1D02:15	Left High Beam: Circuit Short To Battery or Open	If the high beam is inoperative, GO to Pinpoint Test O . If the high beam is always on, GO to Pinpoint Test Q .
B1D03:11	Right High Beam: Circuit Short To Ground	GO to Pinpoint Test O .
B1D03:15	Right High Beam: Circuit Short To Battery or Open	If the high beam is inoperative, GO to Pinpoint Test O . If the high beam is always on, GO to Pinpoint Test Q .
U1000:00	Solid State Driver Protection Actived-Driver Disabled: No Sub Type Information	The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test.
U3000:49	Control Module: Internal Electronic Failure	The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, INSTALL a new BCM. REFER to Multifunction Electronic Modules .
All other DTCs	-	REFER to the DTC Chart in Multifunction Electronic Modules .