Body Control Module (BCM): Installation
WARNING: This page is about a different car, the 2015 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
- 1.NOTE: If installing a new BCM, the ignition cannot be turned on until 2 keys are programmed to the vehicle. The BCM still communicates with the diagnostic scan tool with the ignition off. If necessary, use the previous diagnostic scan tool session or start a diagnostic scan tool session using the PCM part number or tear tag number located on the PCM.NOTE: If installing a new BCM, verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
To install, reverse the removal procedure.
NOTE:
Carry out the remaining steps only if installing a new BCM.
- 2.NOTE: A diagnostic scan tool should not be used to program keys for this specific step.
Program the keys.
- Place the first key in the backup starting location. Refer to: Passive Anti-Theft System (PATS) - Component Location
- Press the START/STOP button and wait approximately 6 seconds.
- Press the START/STOP button and remove the first key.
- Place the second key in the backup starting location.
- Press the START/STOP button.
- 3.
Carry out the parameter reset. Refer to: Anti-Theft Security Access
- 4.
Using a diagnostic scan tool, complete the PMI process for the BCM following the on-screen instructions.
- 5.
Using a diagnostic scan tool, carry out the Configuration Engine Immobilizer (CEI) configuration following the on-screen instructions (Toolbox > Body > Service Functions > CEI Lock Configuration).
- 6.
Using a diagnostic scan tool, carry out the battery monitor sensor reset following the on-screen instructions (Toolbox > Body > BMS Reset).
- 7.
If equipped with video rear parking aid, using a diagnostic scan tool, carry out the new module initialization following the on-screen instructions (Toolbox > Electrical > Service Functions > LIN New Module Initialization).
- 8.
Configure the customer. Reference programmable parameters. Refer to: Module Configuration - System Operation and Component Description
- 9.
Train the tire pressure sensors. Refer to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration