Ignition Coil-On-Plug: Installation

• 1.
  
  Inspect the ignition coil-on-plug rubber boot assembly for cracks, rips, or tears. Replace any damaged coil-on-plug rubber boots.

Courtesy of FORD MOTOR COMPANY

NOTE: Apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation. Material: Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A).
• 2.
  Install the ignition coil-on-plugs and the ignition coil-on-plug mounting bolts. Tighten the ignition coil-on-plug mounting bolts in the following 2 stages.
  • Stage 1: tighten to 7 Nm (62 lb-in).
  • Stage 2: tighten an additional 50 degrees.

Courtesy of FORD MOTOR COMPANY

• 3.
  
  Connect the ignition coil-on-plug electrical connectors and connect the high-pressure fuel pump electrical connector.

Courtesy of FORD MOTOR COMPANY

NOTE: When removing or installing the fuel injection pump noise insulator, spreading the openings will reduce the risk of damage.
• 4.
  Install the fuel injection pump noise insulator.

Courtesy of FORD MOTOR COMPANY

• 5.
  
  Remove the oil filler cap and install the engine appearance cover. Install the oil filler cap.

Courtesy of FORD MOTOR COMPANY