In-Vehicle Repair: Flexplate: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Install the flexplate and the 8 bolts.
- Tighten in the sequence shown to 80 Nm (59 lb-ft).
Fig 1: Flexplate Bolt Tightening Sequence
Courtesy of FORD MOTOR CO.
Install the transaxle. For additional information, refer to Automatic Transmission 6F50 6F55 .
After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.