Clutch Assembly: Inspection
- Check disc for loose rivets, worn springs or oil contamination. Minimum lining height above rivet heads is .012" (.30 mm). Inspect flywheel and pressure plate for burns, scoring or grooves.
- Check runout for flywheel and pressure plate. Resurface or replace flywheel and/or pressure plate if out of specification. See CLUTCH RUNOUT . If flywheel ring gear is replaced, ensure chamfer on flywheel teeth faces engine.
- Mount clutch disc on input shaft. Check runout using dial indicator, replace if out of specification. See CLUTCH RUNOUT . Check disc hub and input shaft splines for excessive wear. Hub must slide smoothly on input shaft splines.
CLUTCH RUNOUT
| Application | In. (mm) |
|---|---|
| Flywheel, Pressure Plate | .008 (.20) |
| Disc | .03 (.7) |