FixVault
Home › Mazda › 1992 › 929 › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System › System Testing › System Diagnostic › Test No. 10

Test No. 10

  1. Check ENGINE fuse. If fuse is faulty, replace fuse (repair circuit if shorted). If fuse is okay, remove starter cut relay. Turn ignition on. Measure voltage at terminal "A" (Black/White wire) of starter cut relay connector. SeeFigure . If battery voltage is not present, repair wiring between ENGINE fuse and starter cut relay.
  2. If battery voltage is present, check continuity between terminals "C" and "F" of starter cut relay. If there is continuity, replace starter cut relay. If there is no continuity, apply battery voltage across starter cut relay terminals "A" and "B". Check continuity between terminals "C" and "F".
  3. If there is no continuity, replace starter cut relay. If there is continuity, turn ignition switch to LOCK position. Install starter cut relay. Turn ignition on.
  4. Measure voltage at terminal 1A (Brown/Yellow wire) of CPU 16-pin connector. If battery voltage is not present, repair wiring between starter cut relay and CPU. If battery voltage is present, replace CPU.
About FixVault