FixVault
Home › Mazda › 1993 › RX-7 Automatic › Repair and Diagnosis › Body & Frame › Door Locks › Anti-Theft System › System Testing › System Operation › Alarm Stop Phase

Alarm Stop Phase

Unlock any door or rear hatch with key.

NOTE: If system does not operate as previously described, use the following procedure to determine where to begin testing.
  1. Open any door window. Close both doors. Remove ignition key. With hood and rear hatch closed, open either door. If security light comes on and buzzer sounds once, go to next step. If security light does not come on and buzzer does not sound, go to TEST NO. 1. If buzzer sounds but security light does not come on, go to TEST NO. 2. If security light comes on but buzzer does not sound, go to TEST NO. 3.
  2. Turn ignition on. If security light does not go out, go to TEST NO. 4. If security light goes out, go to next step.
  3. Perform steps 1) and 2) to set arming condition. Unlock either door lock knob. Security light should go out, horn should sound and headlights and hazard lights should flash. Starter should not operate. If results are as specified, go to next step. If results are not as specified, go to appropriate test.
    • If security light does not go out, go to TEST NO. 5.
    • If horn does not sound, go to TEST NO. 6.
    • If headlights do not flash, go to TEST NO. 7.
    • If hazard lights do not flash, go to TEST NO. 8.
    • If starter operates, go to TEST NO. 9.
  4. Using key, unlock driver or passenger door or rear hatch. Warning should cancel (horn should stop sounding, headlights and hazard lights should stop flashing and starter should operate).
    • If warning cancels when door and rear hatch are unlocked, go to next step.
    • If warning does not cancel when door is unlocked but cancels when rear hatch is unlocked, go to TEST NO. 10.
    • If warning does not cancel when rear hatch is unlocked but cancels when door is unlocked, go to TEST NO. 11.
  5. Remove STOP and HEAD fuses. Perform steps 1), 2) and 3). If hazard lights do not flash, go to TEST NO. 12. If hazard lights do not stop flashing after about 5 minutes, go to TEST NO. 13.
About FixVault