Idle Speed

NOTE: Before adjusting idle speed, warm engine to normal operating temperature. Turn off all accessories. Place transmission in Neutral (M/T) or Park (A/T). Ensure ignition timing is adjusted. See IGNITION TIMING.

Connect Diagnostic Tester (49 B019 9A0) to diagnostic connector and select SELF-TEST mode, or connect jumper wire between diagnostic connector terminals TEN and GND. See Figure . Connect tachometer to diagnostic connector terminal IG (-).
If idle speed is not within specification, rotate idle air adjusting screw on throttle body. See IDLE SPEED SPECIFICATIONS table. Disconnect jumper wire.

IDLE SPEED SPECIFICATIONS

Application

M/T RPM

⁽¹⁾ A/T RPM

929 ⁽²⁾

N/A

700

⁽¹⁾	Place automatic transmission in Park.

⁽²⁾	Connect jumper wire between terminals TEN and GRN of diagnostic connector.