KOEO Wiggle Test
WARNING: This page is about a different car, the 1994 Mazda B3000 and 1994 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
1) Connect test equipment. Turn ignition on. Activate self-test using jumper lead or diagnostic tester. Wait 10 seconds, then deactivate and reactivate self-test. Wiggle test mode is now activated. Tap, move and wiggle suspect sensor and/or harness area.
2) If a fault is detected, scan tester should indicate a tone or light, and VOM will perform needle sweep and/or MIL will come on. A service code may be stored in continuous memory. Retrieve code, and perform appropriate test. See SERVICE CODE REFERENCE.