FixVault
Home › Mazda › 1995 › MPV L › Repair and Diagnosis › External Pages › Different car › Section 19 (Engine Controls - Adjustments) › Throttle Position (TP) Sensor › Throttle Position (TP) Sensor Continuity › Inspection

Throttle Position (TP) Sensor Continuity: Inspection

WARNING: This page is about a different car, the 1995 Mazda MX-3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position and throttle valve to closed throttle position. Disconnect TP sensor connector. Connect ohmmeter between terminals "A" and "B" of TP sensor connector. See Figure . Continuity should exist. If continuity does not exist, adjust T P sensor. See ADJUSTMENT procedure below.
  2. Insert a feeler gauge of specified thickness between throttle lever and throttle stop screw. See TP SENSOR CONTINUITY  . Connect ohmmeter between terminals "A" and "B" of TP sensor connector. See Figure . If continuity is not as specified, adjust TP sensor. See ADJUSTMENT procedure below.
About FixVault