FixVault
Home › Mazda › 1997 › B4000 Base › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › System Testing › System Operation › Test No. 2

Test No. 2

  1. Ensure step 1) in TEST NO. 1 has been completed. Turn ignition on. Using DVOM, measure voltage between terminal No. 7 (Gray/Yellow wire) of servo harness connector and chassis ground. See WIRING DIAGRAMS  . If battery voltage is present, go to next step. If battery voltage is not present, repair blown 7.5-amp fuse No. 10 located in instrument panel fuse block, or open in Gray/Yellow wire.
  2. Turn ignition off. Using DVOM, measure resistance between terminal No. 10 (Pink/Orange wire) of servo harness connector and chassis ground. see WIRING DIAGRAMS  . If resistance is less than one ohm, go to step 1) in TEST NO. 1. If resistance is one ohm or more, repair open in Pink/Orange wire.
About FixVault