FixVault
Home › Mazda › 1997 › MX-6 Base, Standard › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › Diagnosis › Condition Detection Mode › Using Cruise Indicator Light

Using Cruise Indicator Light

  1. Turn ignition on. Turn main switch on. Ensure cruise indicator light illuminates. If cruise indicator light does not illuminate, service before continuing.
  2. Activate RESUME/ACCEL switch for at least 3 seconds. Cruise indicator light will illuminate for 3 seconds, and then go out for 2 seconds. Cruise indicator light will flash condition detection mode DTCs (if set). See CONDITION DETECTION MODE DTCS  . A long pause separates DTCs. On 2-digit DTCs, a short pause separates each digit of DTC (example of DTC 15: long flash, short pause, 5 short flashes).
  3. If no DTCs are set, light will not flash. To cancel condition detection mode, drive vehicle at a speed greater than 10 MPH or turn main switch off. Ensure cruise indicator light goes out.
About FixVault