Clutch Assembly: Installation

1. If replacing pilot bearing, drive in NEW pilot bearing until distance between pilot bearing and end of crankshaft is 0-0.016" (0-0.4 mm). Ensure all bolts are clean and free of old sealant. Coat bolt threads with Stud & Bearing Mount Sealer (EOAZ-19554-B).
2. Position clutch disc onto flywheel, with damper springs facing outward. Retain disc in place with clutch aligner. Position pressure plate over clutch disc and align marks made at removal (if reusing pressure plate).
3. Install and tighten bolts to specification in a crisscross pattern. See TORQUE SPECIFICATIONS  . Remove clutch aligner. Lightly coat input shaft splines with lithium grease.
4. Install transaxle assembly by aligning input shaft through clutch disc splines. Align clutch housing onto engine guide pins. Install and tighten clutch housing bolts to specification. See TORQUE SPECIFICATIONS. To complete installation, reverse removal procedure.

Fig 1: Exploded View Of Clutch Assembly (Typical)

Courtesy of MAZDA MOTORS CORP.