Input/Output Check Mode
NOTE:
DTCs must be accessed in numerical order. If a lower number DTC needs to be accessed, discontinue test and start over.
- Turn ignition to LOCK position. Disconnect negative battery cable. After more than 30 seconds, reconnect negative battery cable. Cycle ignition switch to ON position then LOCK position, 3 times. Turn ignition switch to ON position. Push trip reset button 3 times.
- Push trip reset button and select appropriate DTC. See DTC DEFINITIONS table. Inspect DTC by following procedures under appropriate DTC. To cancel input/output check mode, turn ignition to LOCK position then back to ON position.
DTC DEFINITIONS
| DTC | Definition |
|---|---|
| 10 | Vehicle Speedometer Sensor |
| 11 | PCM |
| 12 | Speedometer |
| 13 | Tachometer |
| 16 | Fuel Level Warning Light |
| 22 | Fuel Gauge Sending Unit |
| 23 | Fuel Gauge |
| 24 | Temperature Gauge Sending Unit |
| 25 | Temperature Gauge |
| 26 | LCD |