Load compensation inspection: Notes
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Start the engine and run is at idle.
- Connect the WDS or equivalent to the DLC-2.
- Verify that P0506, P0507 or P0511 are not displayed.
- If P0506, P0507 or P0511 are displayed, perform DTC inspection. (See DTC TABLE .)
- Select the RPM PID.NOTE:
- Excludes temporary idle speed drop just after the loads are turned on.
- Verify that the engine speed is within the specification under each load condition.
- If not as specified at specific load condition, inspect the following:
- A/C switch and related harness (See CLIMATE CONTROL UNIT INSPECTION .)
- Fan switch and related harness (See CLIMATE CONTROL UNIT INSPECTION .)
- PSP switch and related harness (See POWER STEERING PRESSURE (PSP) SWITCH INSPECTION .)
- If not as specified at specific load condition, inspect the following: