Continuity Inspection: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the clutch switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
Inspect for continuity between the clutch switch terminals B and D using an ohmmeter.
- If the clutch switch is okay, but the PID value is out of specification, perform the "Circuit Open/Short Inspection".
- If not as specified, replace the clutch switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
  
  Fig 1: Identifying Clutch Switch Connector Terminals
  Courtesy of MAZDA MOTORS CORP.