Stop Pin and O-ring (with ABS/TCS) Assembly Note
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Install the secondary piston with the piston hole facing the stop pin and primary piston.
- Install the new O-ring onto the stop pin.
- Push the primary piston assembly in fully.
- Install and tighten the stop pin.
Tightening torque
6.9-9.8 N.m {71-99 kgf.cm, 62-86 in.lbf}
- Push and release the secondary piston component to verify that it is held properly by the stop pin.