FixVault
Home › Mazda › 2000 › MPV ES › Repair and Diagnosis › External Pages › Different car › Section 398 (Automatic Transaxle [Shift Mechanism]) › Selector Lever Component Removal/Installation › Notes

Selector Lever Component Removal/Installation: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts.
    1. Battery and battery tray
    2. Air cleaner component (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION [L3] .) (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION [AJ] .)
    3. Center console
    4. Dashboard completely (See DASHBOARD REMOVAL/INSTALLATION .)
    5. SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION .)
    6. Climate control unit (See CLIMATE CONTROL UNIT REMOVAL .) (See CLIMATE CONTROL UNIT INSTALLATION .)
    7. Rear heat duct (See REAR HEAT DUCT REMOVAL/INSTALLATION .)
  3. Remove in the order shown in the figure.
    Fig 1: Removing Transaxle Shift Mechanism (Torque Specs)
    G03644899Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
About FixVault