Side Protector Installation
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor.
- Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body.
- Attach double-sided adhesive tape to the side protector as shown (if it will be reused).
Clearance
a: 50.0 mm {1.97 in}
b: 2.0 mm {0.79 in}
c: 12.0 mm {0.47 in}
d: 3.0 mm {0.11 in}
e: 3.0 mm {0.11 in}
f: 1.0-3.0 mm {0.04-0.11 in}
g: 5.0 mm {0.19 in}
h: 1.0 mm {0.04 in}
- Peel off the backing of the double-sided adhesive tape and attach the side protector onto the body as shown.
Clearance
a: 1.2-4.2 mm {0.05-0.16 in}
b: 3.2-6.2 mm {0.13-0.24 in}