FixVault
Home › Mazda › 2001 › 626 ES, 2.5 D, Standard › Repair and Diagnosis › Brakes › Anti-Lock/Traction Control › Abs Hydraulic Unit And Control Module Removal/Installation › Abs Control Module Removal Note

Abs Control Module Removal Note

  1. Install the screw plugs (supplied in the service part kit) onto the brake pipe holes of the HU.
  2. Disconnect the motor connector as follows.
    CAUTION:
    • Do not apply force on the locking tab when disconnecting the connector.
    1. Lift up the tab to unlock the connector by hand.
    2. Pull the connector from the ABS CM by grasping the side of the motor connector.
  3. Carefully pull the wiring of the pump motor out of the cable guides.
    Fig 1: Carefully Pulling Wiring Of The Pump Motor
    G02192148
  4. Secure the HU as shown.
  5. Remove the bolts.
    Fig 2: Removing Bolts
    G02192149
  6. Protect the HU from damage to the valve body and keep the sealing surface free from foreign materials.
About FixVault