Input/Output Check Mode
NOTE:
Access DTC's in numerical order. If a lower number DTC needs to be accessed, discontinue test and start over.
- Turn ignition switch to LOCK position. Disconnect negative battery cable. After more than 30 seconds, reconnect negative battery cable. Cycle ignition switch to ON position, then LOCK position, 3 times. Turn ignition switch to ON position. Push trip reset button 3 times.
- Push trip reset button to select appropriate DTC. DTC's are displayed on trip/odometer LCD. See DTC DEFINITIONS table. Inspect DTC by following procedures under appropriate diagnostic test. See DIAGNOSTIC TESTS . To cancel input/output check mode, turn ignition to LOCK position, then back to ON position.
DTC DEFINITIONS
| DTC | Definition |
|---|---|
| 01 | Buckle Switch ON/OFF Signal |
| 04 | Door Switch ON/OFF Signal |
| 05 | Door Lock-Link Switch ON/OFF Signal |
| 07 | Rear Window Defroster Switch ON/OFF Signal |
| 08 | TNS Relay ON/OFF Signal |
| 10 | Vehicle Speed Input Signal |
| 11 | Engine Speed Input Signal |
| 12 | Operation Signal To Speedometer |
| 13 | Operation Signal To Tachometer |
| 14 | Operation Signal To Buzzer |
| 16 | Operation Signal To Fuel Level Warning Light |
| 17 | Operation Signal To Rear Window Defroster Indicator Light |
| 18 | Ignition Key Illumination ON/OFF Signal |
| 20 | Operation Signal To Rear Window Defroster Switch ON/OFF Signal |
| 22 | Fuel Level Signal |
| 23 | Operation Signal To Fuel Gauge |
| 24 | Water Temperature Signal |
| 25 | Operation Signal To Water Temperature Gauge |
| 26 | LCD Indication |
| 27 | Operation Signal To Interior Light |
| 31 | Key Reminder ON/OFF Signal |
| 41 | Shift Lock Solenoid ("P" Position Signal) ON/OFF Signal |
| 42 | Operation Signal To Interlock Solenoid |