Inspection Method For Switch Connectors Or Wires
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the WDS or equivalent to the DLC-2.
- Turn ignition switch to ON position (Engine OFF).NOTE:
- If the engine starts and runs, perform the following steps at idle.
- Access the PIDs for the switch you are inspecting.
- Turn the switch on manually.
- Shake each connector or wiring harness a bit vertically and horizontally while monitoring the PID.
- If the PID value is unstable, check for poor connection.