FixVault
Home › Mazda › 2003 › MPV ES › Repair and Diagnosis (Single Page) › Body & Frame › Exterior Body Panels › Doors And Liftgate › Easy Closure Control Module Removal/Installation

Easy Closure Control Module Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the sliding door trim.
  3. Remove the screws, and remove the easy closure control module.
  4. Disconnect the easy closure control module connector.
    Fig 1: Removing Easy Closure Control Module
    G01884059Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
About FixVault